René Herse Cranks in Stock

René Herse Cranks in Stock

We just received a new shipment of René Herse cranks. In addition to the double and triple cranks, this production run includes the single-speed cranks (shown above). We also have all chainring sizes in stock (except 50 teeth, which are due to arrive in Seattle in a few days).

The single-speed cranks are machined differently on the back (above): There is no shelf for the second chainring, and the chainring nuts are recessed into the spider. Not only does this look nice, but it allows you to run an ultra-narrow tread (Q factor).

We now also have the new René Herse tandem cranks in stock. The left-side chainrings always are 30 teeth. Since these rings don’t need to shift, we gave them a special tooth profile for extra-long wear. For the right-side crank, you have the same choice of single/double/triple chainrings in all sizes between 24 and 50 teeth.

We now offer the chainring bolts and spacers separately, so you can convert your cranks from double to triple or vice versa.
We appreciate your patience while we worked on the second production run. It takes time and dedicated work to maintain our high quality standards, and our engineer in Taiwan has been working overtime to make this happen. We think the end product is worth the wait. More information on the René Herse cranks is here.

Share this post

Comments (5)

  • rodneyAB


    October 10, 2012 at 8:51 pm
  • Willem

    Great news, en good that there are now also singles. However, one of the most important uses for single cranks these days (perhaps less so in the US) is in combination with a Rohloff hub (the ideal loaded touring gear system for me). But for those you need a 38 or 40t ring to get the required low gearing. 40×17 and 38×16 are the lowest gearing combinations allowed by Rohloff,and perfect for loaded touring in most people’s experience. The Herse outer rings only go down to 44t, and I can tell from experience that that is way too big for a Rohloff hub. Rohloff also do a heavy duty 21t sprocket that would work with a 50t ring, but that makes for a rather heavier combination that is only sensible on epic expeditions.

    October 11, 2012 at 1:09 am
  • Mitchell

    Jan, have you thought about reproducing Maxi-car hubs? And Nivex derailleurs?

    October 12, 2012 at 4:10 am
    • Jan Heine, Editor, Bicycle Quarterly

      To do these projects right, you have to focus on one project at a time. We have other projects in the pipeline, but we will give each project our full attention to make sure it meets our high standards.

      October 12, 2012 at 7:06 am

Comments are closed.

Are you on our list?

Every week, we bring you stories of great rides, new products, and fascinating tech. Sign up and enjoy the ride!

* indicates required